Show Ipv6Route - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Format
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr> |
ip_tunnel <tunnel_name 12>] | all]
Parameters
default - Specifies the default route.
<ipv6networkaddr> - Specifies the IPv6 network address.
<ipif_name 12> <ipv6addr> - Specifies the IP interface name.
<ipv6addr> - Specifies the next hop address for the IPv6 route
ip_tunnel - Specifies the IPv6 tunnel name used. (EI Mode Only Parameter)
<tunnel_name 12> - Enter the IPv6 tunnel name used here. This name can be up to 12
characters long.
all - All created static routes will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IPv6 static route:
DGS-3620-28SC:admin#delete ipv6route default System FEC0::5
Command: delete ipv6route default System FEC0::5
Success.
DGS-3620-28SC:admin#
47-6

show ipv6route

Description
This command is used to display the Switch's current IPv6 routing table.
Format
show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {[static | ripng | ospfv3 | hardware]}
Parameters
<ipv6networkaddr> - (Optional) Specifies the IPv6 destination network address of the route.
<ipv6addr> - (Optional) Specifies the IPv6 address.
static - (Optional) Specifies the static route entries.
ripng - (Optional) Specifies the RIPng route entries. (EI Mode Only Parameter)
ospfv3 - (Optional) Specifies the OSPFv3 route entries. (EI Mode Only Parameter)
hardware - (Optional) Specifies the route entries which have been written into hardware table.
Restrictions
None.
580