D-Link xStack Reference Manual page 1040

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<portlist> - Enter the ports to be configured.
all - Specifies to configure all ports.
analyzer_server_id - Specifies the ID of an analyzer server where the packet will be forwarded.
<value 1-4> - Enter the ID of an analyzer server where the packet will be forwarded.
interval - (Optional) Specify the maximum number of seconds between successive statistic
counters information. If set to disable, the counter-poller is disabled. If the interval is not
specified, its default value is disable.
disable - Specifies to disable the interval.
<sec 20-120> - Enter the interval, in seconds, between 20 and 120.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create the sFlow counter poller:
DGS-3620-28SC:admin#create sflow counter_poller ports 1 analyzer_server_id 1
Command: create sflow counter_poller ports 1 analyzer_server_id 1
Success.
DGS-3620-28SC:admin#
92-12 config sflow counter_poller ports
Description
This command is used to configure the sflow counter poller parameters. If a user wants to change
the analyzer server ID, they need to delete the counter poller and create a new one.
Format
config sflow counter_poller ports [<portlist> | all] interval [disable | <sec 20-120>]
Parameters
<portlist> - Enter the ports to be configured.
all - Specifies to configure all ports.
interval - Specifies the maximum number of seconds between successive samples of the
counters. If set to disabled, the counter sample is disabled.
disable - Specifies to disable the interval.
<sec 20-120> - Enter the interval, in seconds, between 20 and 120.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the sFlow counter poller parameters interval to 50 for port 1:
1035