D-Link xStack Reference Manual page 599

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
None. (EI Mode Only Command)
Example
To show an IP tunnel interface's information (Tunnel name is "tn2"):
DGS-3620-28SC:admin# show ip_tunnel tn2
Command: show ip_tunnel tn2
Tunnel Interface
Interface Admin State
Tunnel Mode
IPv6 Address
Tunnel Source
Tunnel Destination
DGS-3620-28SC:admin#
48-7 enable ip_tunnel
Description
This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch.
Format
enable ip_tunnel {<tunnel_name 12>}
Parameters
<tunnel_name 12> - (Optional) Enter the IP tunnel interface name used here. This name can be
up to 12 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only
Command)
Example
To enable an IP tunnel interface (Tunnel name is "tn2"):
: tn2
: Enabled
: Manual
: 2000::1/64
: 1.0.0.1
: 1.0.0.2
594