D-Link xStack Reference Manual page 848

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create an OSPF area:
DGS-3620-28SC:admin# create ospf area 10.48.74.122 type stub stub_summary
enabled metric 1
Command: create ospf area 10.48.74.122 type stub stub_summary enabled metric 1
Success.
DGS-3620-28SC:admin#
73-7 config ospf area
Description
This command is used to configure an OSPF area's settings.
Format
config ospf area <area_id> type [normal | [stub | nssa {translate [enable | disable]}]
{stub_summary [enable | disable] | metric <value 0-65535>}]
Parameters
<area_id> - Enter the OSPF area ID used here.
type - Specifies the OSPF area operation type. In some Autonomous Systems, the majority of
the topological database may consist of AS external advertisements. An OSPF AS external
advertisement is usually flooded throughout the entire AS. However, OSPF allows certain
areas to be configured as "stub areas". AS external advertisements are not flooded
into/throughout stub areas; routing to AS external destinations in these areas is based on a
(per-area) default only. This reduces the topological database size, and therefore the memory
requirements, for a stub area's internal routers.
normal - Specifies that the OSPF area type will be set to normal.
stub - Specifies that the OSPF area type will be set to STUB.
nssa - Specifies that the OSPF area type will be set to NSSA.
translate - (Optional) Specifies whether translation will be enabled or disabled.
enable - Specifies that the translate option will be enabled.
disable - Specifies that the translate option will be disabled.
stub_summary - (Optional) Specifies whether the summary LSA is effective for this area.
enable - Specifies that the STUB summary option will be enabled.
disable - Specifies that the STUB summary option will be disabled.
metric - (Optional) Specifies the metric (1 - 65535; 0 for auto cost) of this area.
<value 0-65535> - Enter the metric value used here. This value must be between 0 and
65535.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
843