D-Link xStack Reference Manual page 396

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Parameters
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specifies that all the ports will be used for this configuration.
state - Specifies the state of the DHCP relay function for each port.
enable - Specifies that the DHCP relay function, for the specified port(s), will be enabled.
disable - Specifies that the DHCP relay function, for the specified port(s), will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the DHCP relay function on ports 1 to 3:
DGS-3620-28SC:admin#config dhcp_relay ports 1:1-1:3 state enable
Command: config dhcp_relay ports 1:1-1:3 state enable
Success.
DGS-3620-28SC:admin#
23-22 show dhcp_relay ports
Description
This command is used to show the DHCP relay port configuration.
Format
show dhcp_relay ports {<portlist>}
Parameters
<portlist> - (Optional) Enter the list of ports, used for this display, here.
If no parameter is specified, information for all ports will be displayed.
Restrictions
None.
Example
To display the DHCP relay state of ports 1 to 10:
DGS-3620-28SC:admin#show dhcp_relay ports 1:1-1:10
Command: show dhcp_relay ports 1:1-1:10
Port DHCP Relay State
---- ----------------
1:1 Enabled
391