D-Link xStack Reference Manual page 631

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3620-28SC:admin# show address_binding nd_snoop binding_entry
Command: show address_binding nd_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address
----------------------------------------- ------------------ -- -------- ----
2001:2222:1111:7777:5555:6666:7777:8888
2001::1
Total Entries : 2
DGS-3620-28SC:admin#
50-25 clear address_binding nd_snoop binding_entry ports
Description
This command is used to clear the ND snooping entries on specified ports.
Format
clear address_binding nd_snoop binding_entry ports [<portlist> | all]
Parameters
ports - Specifies the list of ports that you would like to clear the ND snoop learned entry.
<portlist> - Enter the list of port used here.
all - Clear all ND snooping learned entries.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear ND snooping entry on ports 1-3:
DGS-3620-28SC:admin# clear address_binding nd_snoop binding_entry ports 1-3
Command: clear address_binding nd_snoop binding_entry ports 1-3
Success.
DGS-3620-28SC:admin#
50-26 config address_binding dhcp_snoop_entry filename
Description
This command is used to configure the autosave state of DHCPv4 Snooping binding entries.
MAC Address
00-00-00-00-00-02
00-00-00-00-03-02
626
S LT(sec) Port
I 50 5
A 100 6