Show Iproute - D-Link xStack Reference Manual

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide
Command: delete iproute default 10.48.74.121
Success.
DGS-3620-28SC:admin#
47-3

show iproute

Description
This command is used to display the Switch's current IP routing table.
Format
show iproute {[<network_address> | <ipaddr>]} {[static | rip | ospf | bgp | hardware]}
Parameters
<network_address> - (Optional) Specifies the destination network address of the route want to
be displayed.
<ipaddr> - (Optional) Specifies the destination IP address of the route want to be displayed. The
longest prefix matched route will be displayed.
static - (Optional) Specifies to display only static routes. One static route may be active or
inactive. Note: Active or inactive means the device detected a physical link failure (link down).
rip - (Optional) Specifies to display only RIP routes.
ospf - (Optional) Specifies to display only OSPF routes.
bgp - (Optional) Specifies to display only BGP routes. (EI Mode Only Parameter)
hardware - (Optional) Specifies to display only the routes that have been written into the chip.
Restrictions
None.
Example
To display the contents of the IP routing table:
DGS-3620-28SC:admin#show iproute
Command: show iproute
Routing Table
IP Address/Netmask
------------------
10.0.0.0/8
Total Entries : 1
DGS-3620-28SC:admin#
Gateway Interface
--------------- ------------
0.0.0.0 System
578
Cost Protocol
-------- --------
1 Local