Table of Contents
Advertisement
The optional Intelligent Lens System (ILS) automates the process of adjusting the Focus, Horizontal (X) and
Vertical (Y) Offset, and Zoom in real-time using a motorized lens mount. ILS settings are saved in a file named
ILS Flat or ILS Scope.
An anamorphic lens (1.25x) can be installed into the optional auxiliary lens mount, then swung into place in
front of the primary lens to widen a "squeezed" image into a properly proportioned "scope" anamorphic
display.
5.6.1 Enable Automatic ILS Selected
When the Enable Automatic ILS check box is selected, the ILS adjusts each motor for the focus, offset, and
zoom to automatically move the lens based on the settings in the selected ILS file. Changing channels will
change the position of the lens, assuming the new channel uses a different ILS file. To make adjustments to an
ILS file, use the motorized lens mount adjustment features in the Advanced Setup: ILS File Setup window or
Lens Adjust window from the Main panel to adjust the focus, zoom and offset values. NOTE: Any changes
made to the focus, offset and zoom values will overwrite the current values in the ILS file, therefore these
changes will affect every channel that uses this ILS file.
5.6.2 Enable Automatic ILS NOT Selected
When the Enable Automatic ILS check box is NOT selected, the lens does not move unless you make
adjustments to the focus, offset and zoom from the Lens Adjust window launched from the Main panel (the
ILS File Setup window is not available when the
settings will NOT overwrite the ILS values and changing channels will not affect the position of the lens.
The following table provides an example of what happens to the lens position and saved ILS Flat values when
you adjust the focus, zoom, and offset in both states of the Enable Automatic ILS feature.
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
Motorized Vertical Offset
Horizontal Boresight Bolt
Horizontal Offset Knob
Motorized Horizontal Offset
Figure 5-2 Anatomy of the Lens Mount
Vertical Offset Knob
Motorized Zoom
Anchor Bolt
Lock/Unlock Lens
Focus
Vertical Boresight
check box is not selected). These
Enable Automatic ILS
Section 5: Projector Operation
5-5
Advertisement
Table of Contents
