Table of Contents
Advertisement
Section 2: Installation and Setup
3. Remove the cover from the zoom motor mount with a Phillips screwdriver. Keep the hardware and cover.
4. Install zoom gear ring and adapter onto the lens.
NOTE: 1) Use a small adapter for lens 1.8-3.0. 2) Use a large adapter for lens 1.45-2.05, 2.15-3.6, 1.25-
1.83:1 3) All other lenses do not need an adapter.
5. Verify that there is full travel of the gear ring, and the alignment of the sensor is correct.
NOTE: There must be a small gap between the gears to prevent binding. To ensure there is a gap, loosen
the screws and readjust the gap. Tighten the screws when you have completed the adjustment.
2-10
Figure 2-10
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
Advertisement
Table of Contents
