Table of Contents
Advertisement
Section 6: Projector Menus
Figure 6-19 Advanced Setup: LampLOC™ Setup Window
Table 6.17 Advanced Setup: LampLOC™ Setup Window
Control
Value
Light Bar
Do Auto
Display Full
Screen White
Test Pattern
Auto
LampLOC™
Progress Bar
Cancel Auto
6-26
1
3
Description
Moves the lamp up, down, in, out, left, and right. The current position of the lamp displays in Cartesian
coordinates. Tap once to increase or decrease the lamp position by a single increment. Press and hold a
button to increase or decrease the lamp position by multiple increments. You cannot move the lamp
beyond the pre-defined limits for the projector. For D4K25 X/Y = +/-250; Z = +/-175.
Shows the current light sensor reading in arbitrary units-of -measure and does not represent actual
lumens or fL.
Indicates the current light intensity (vertical bar) and LiteLOC
Starts the auto LampLOC
™
calibration procedure, which adjusts the lamp position until the highest light
reading is obtained from the light sensor.
Temporarily displays a full screen white test pattern for the duration of the LampLOC™ adjustment.
The previous display reappears when you close the LampLOC™ Setup page or clear the check box.
Shows the current LampLOC
Cancels the LampLOC calibration.
procedure completion status.
™
2
LiteLOC™
Target
Light
Intensity
™
target (red horizontal line).
020-100882-02 Rev. 1 (07-2012)
D4K25 User Manual
Advertisement
Table of Contents
