Table of Contents
Advertisement
2 Installation and Setup
This section explains how to install, connect, and optimize the projector display.
2.1
Site Requirements
To safely install and operate the D4K25 projector, the installation location must meet these minimum
requirements:
• Physical Operating Environment
• Maximum Ambient Temperature (operating) 35°C
• Minimum Ambient Temperature (operating) 10°C
• External Exhaust Ducting
• The installation site must provide a minimum of 450 CFM (ft
adequate cooling of the Xenon arc lamp at less than or equal to 25°C ambient and less than 3,000 feet ele-
vation. Above 25°C or 3,000 feet, 600 CFM is required. For detailed instructions for measuring CFM, see
2.8 Connect External Exhaust Ducting, on page 2-8.
• Permanent Power Connection
• A 30A maximum double pole, UL listed wall circuit breaker is required. It must be part of the building
installation and easily accessible.
• Single-phase projector unit: Maximum 15A circuit breaker protection provided as part of the building
installation
• Protection from overcurrents, short circuits, and earth faults must be part of the building installation.
• Protection from overcurrents, short circuits, and earth faults must be part of the building installation. The
disconnect device (double pole switch or circuit breaker with minimum 3mm contact gap) must be readily
accessible within the projection room.
• This product can be connected to an IT power distribution system.
2.2
Tools Required for Installation
You need these tools to install the D4K25 projector:
• 12" screwdrivers: Phillips #2 (magnetic) and flat
• 19mm and 7/8" wrenches
• Assorted Allen keys (metric)
• Heat extractor
• Christie approved protective safety clothing if you are working with the lamp
• Lamp
• Lens cleaning tissue and solution
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
3
/min) external exhaust airflow to ensure
2-1
Advertisement
Table of Contents
