Table of Contents
Advertisement
Time/Date (TMD) (Continued)
Set Time Offset in seconds (± 900 seconds). Must be powered ON. (Write-only)
TOFF
Set/get the time zone
ZONE
EXAMPLES:
(TMD+DSTA?) 0 or 1 (DST OFF or DST ON)
(TMD+DSTA 0) Turn daylight savings OFF (0) or ON (1)
(TMD+ZONE 20) Set time zone to EST
(TMD+TIME? ) Get local time (TMD+TIME! 17:50:45)
(TMD+TOFF 120) Increase the time by two minutes.
("TMD+TOFF: Disabled Control") Error message returned when power is OFF.
3D Output Reference Polarity (TOP)
Setup output timing signal reference polarity for 3D control.
SUBCODE
DESCRIPTION OF USE
Replace xxx with the channel number. Valid range is 101-164.
Cxxx
Select output reference polarity for the current channel.
NONE
EXAMPLES:
(TOP+C101 1) Set Output Reference Polarity to 1 on channel 101
(TOP+C101?) Get Output Reference Polarity on channel 101
User ID (UID)
Allows users to login to the serial interface.
SUBCODE
DESCRIPTION OF USE
None
NONE
EXAMPLES:
(UID) "username" "password") Login a user
(UID) Logout the current user, also happens automatically when a new user logs in
(UID?)(UID! "username" 01) Display the current logged in user and their access level
Zoom Lens Position Adjustment (ZOM)
Adjust lens to specific zoom position with a specified direction (1, -1). NOTE: This command can only be used to
update the current ILS file. Changing the zoom for the current channel will change the zoom for any channel using
the same ILS file.
Use command without subcode:
• If ILS is ON, motor will move to specified steps and save data to the active channel.
• If ILS is OFF, motor will move to specified steps, do not save data to the active channel.
SUBCODE
DESCRIPTION OF USE
Motor backlash in negative direction. Read-only.
BACN
Motor backlash in positive direction. Read-only.
BACP
Calibrate travel range and backlash on specified. Only valid parameter for this command is 1. Set only
CALB
command.
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
Appendix B: Serial API
B-25
Advertisement
Table of Contents
