Table of Contents
Advertisement
2.9
Remove the Shroud
To access the MLM and lens, you need to remove
one shroud. Remove the second shroud when you
use a Motorized Auxiliary Lens Mount or a Real
D Z or plug AC power cord into front face of the
projector.
1. Using finger pressure, push down on the
locations specified by the red arrows in the
diagram.
2. Carefully slide the shroud sideways and
forward away from the MLM and lens.
3. Place the shroud cover on a clean surface to
prevent scratches.
2.10 Install the Primary Lens
The lens seals the projection head, preventing contaminants from entering the main electronics area. Do not
operate the projector without a lens installed. Install a lens plug when you install or transport the projector.
NOTE: 1) Make sure the zoom ring is against the front of motor mount for lenses: 1.6-2.4:1, 1.8-3.0:1, 2.15-
3.6:1. 2) Make sure the zoom ring is against the back of motor mount for lenses: 1.45-2.05:1, 1.25-1.83:1. 3)
All other lenses: Leave a gap between the rotating zoom section of lens and motor mount.
1. Unpack the zoom motor kit.
2. Use a flathead screwdriver to install the zoom motor mount onto the lens with a screw clamp.
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
Section 2: Installation and Setup
Figure 2-9 Shroud Removal
2-9
Advertisement
Table of Contents
