Table of Contents
Advertisement
2.7
Install the Touch Panel Controller (TPC)
1. Loosen the mounting arm so that the end fits over the ball joint located on the rear panel of the projector.
2. Tighten the mounting arm until it fits tightly on the joint.
3. Connect the cable from the TPC to the connector on the rear panel of the projector.
4. Adjust the angle of the TPC.
D4K25 User Manual
020-100882-02 Rev. 1 (07-2012)
Figure 2-4 Using the Foot Extension Rods
Figure 2-5
Figure 2-6
Section 2: Installation and Setup
2-7
Advertisement
Table of Contents
