Installing The Speaker; Side Access Panel Sensor (Optional); Removing The Side Access Panel Sensor - HP Z800 Maintenance And Service Manual

4. Disconnect the speaker cable from the inline front panel I/O cable (1), and slide the speaker from
the chassis flanges (2), as shown in the following figure.
Figure 5-12

Installing the speaker

To install the speaker, reverse the removal steps.

Side access panel sensor (optional)

The side access panel sensor is a switch that detects when the side access panel is opened.
This section describes how to remove and install the side access panel sensor.

Removing the side access panel sensor

1. Disconnect power from the workstation (see
2.
Remove the side access panel (see
3. Remove the power supply from the chassis (see
88 Chapter 5 Replacing components
Removing the speaker
Removing the side access panel on page
Predisassembly procedures on page
Removing the power supply on page
77).
79).
86).
ENWW