Workstation speaker
This section describes how to remove and install the workstation speaker.
Removing the workstation speaker
To remove the workstation speaker:
1.
Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4.
Remove the front bezel (see
5.
Disconnect the speaker cable from the system board (1), as shown in the figure below.
6.
Remove the two speaker mounting screws (2).
7.
Remove the speaker by sliding it away from the front panel into the chassis (3).
Figure 5-24
Installing the workstation speaker
To install the speaker, reverse the previous steps.
ENWW
Predisassembly procedures on page
Removing the side access panel on page
Removing the front bezel on page
Removing the workstation speaker
Predisassembly procedures on page
83).
Removing and installing components
75).
75).
78).
97