HP Z800 Maintenance And Service Manual page 53

Table 4-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Advanced
2
ENWW
Option Description
Power-On Enables you to set the following:
Options
● POST Messages—Enables or disables the splash screen during POST.
F9 Prompt (Displayed or Hidden)—Selecting Displayed displays the F9=Boot Menu
●
during POST. Selecting Hidden prevents the text from being displayed. However, pressing
F9 still accesses the boot menu.
● F10 Prompt (Displayed or Hidden)—Selecting Displayed displays F10=Setup during
POST. Selecting Hidden prevents the text from being displayed, but pressing F10
still accesses the Setup screen.
F12 Prompt (Displayed or Hidden)—Selecting Displayed displays F12=Network
●
Service Boot during POST. Selecting Hidden prevents the text from being displayed
but pressing F12 still forces the workstation to attempt booting from the network.
Option ROM
●
display a message before loading options ROMs.
Remote Wakeup Boot Source—Enables you to set the remote wakeup boot source as:
●
Local Hard Drive
◦
◦ Remote Server
After Power Loss (On, Off, Previous State)—Enabling this option directs the previous state to
●
be the default.
POST Delay (in seconds) (5, 10, 15, 20, None)—Adds a specified delay to the POST
●
process. This delay is sometimes needed for hard disk drives on some expansion cards that
spin up slowly (so slowly that they are not ready to start by the time POST is finished). The
POST delay also gives you time to select F10 to enter the Computer Setup (F10) Utility.
BIOS Power-On Enables you to disable or specify a weekday and time for BIOS power-on.
Processors Enables/disables these options:
Hyper-Threading—Provides processor parallelization such that the operating system treats
●
one processor as two.
Active Cores (1,2, or All Cores)—Selects a single core, or multiple cores per socket. (Not
●
available on some configurations.)
Limit CPUID Maximum Value to 3 (Enable or Disable)—Sets the number of allowable CPU
●
IDs.
Onboard Enables you to set resources (IRQ, DMA, I/O Rate) for or disable onboard system devices such as
Devices serial port and diskette controller. Operating system parameters generally override Onboard
Devices settings.
PCI VGA Configures graphics cards per workstation slots. In multi-graphics card configurations, this option
Configuration designates one card as primary graphics, and the other card as secondary graphics.
prompt (Enable or Disable)—Enabling this feature causes the workstation to
1
The Computer Setup (F10) Utility
41