Right side panel
This section describes how to remove and install the right side panel.
Removing the right side panel
NOTE:
Use this procedure to access the backplane wiring.
1.
Disconnect power from the workstation (see
2.
Remove the two T-15 Torx screws (1), and then slide the right side panel in the direction shown in
the following figure until it stops, and then lift off the chassis (2).
Figure 5-10
Installing the right side panel
To install the panel, slide it into position on the workstation, and then fasten it with two T-15 Torx
screws.
Power supply
This section describes how to remove and install a power supply.
Removing the power supply
1.
Disconnect power from the workstation (see
2.
Remove the side access panel (see
86
Chapter 5 Replacing components
Removing the right side panel
Removing the side access panel on page
Predisassembly procedures on page
Predisassembly procedures on page
77).
77).
79).
ENWW