Tools And Software Requirements; Special Handling Of Components; Cables And Connectors - HP Z800 Maintenance And Service Manual

Tools and software requirements

The tools necessary for workstation component removal and installation are:
Torx T-15 driver
●
Flat blade and cross-tip screwdrivers
●
Diagnostics software
●

Special handling of components

The components included in this section require special handling when servicing the workstation.
WARNING!
workstation. Lifting the workstation from the front bezel, or lifting it incorrectly, could cause the
workstation to fall, causing possible injury to you and damage to the workstation. To properly and
safely lift the workstation, lift from the bottom of the workstation.
WARNING!
workstation. Lifting the workstation from the front bezel, or lifting it incorrectly, could cause the
workstation to fall, causing possible injury to you and damage to the workstation. To properly and
safely lift the workstation, use the handles. If the workstation is not equipped with handles, lift from the
bottom of the workstation.

Cables and connectors

Handle cables with care to avoid damage. Apply only the tension required to seat or unseat cables
during insertion or removal from the connector. When possible, handle cables by the connector or pull-
strap. In all cases, avoid bending or twisting the cables, and be sure that the cables are routed in such
a way that they cannot be caught or snagged by parts being removed or replaced.
When servicing the workstation, be sure that cables are placed in their proper location during the
reassembly process. Improper cable placement can damage the workstation.
ENWW
Do not use the front bezel as a handle or lifting point when lifting or moving the
Do not use the front bezel as a handle or lifting point when lifting or moving the
Service considerations 71