Cable Lock (Optional) - HP Z800 Maintenance And Service Manual

Setting the Side access panel sensor protection level
To set the Side access panel sensor protection level:
1.
Power on or restart the workstation.
2. As soon as the workstation is powered on, press and hold the
Computer Setup (F10) Utility. Press
NOTE:
and then press and hold the
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
3. Select Security>Smart Cover>Cover Removal Sensor, and follow the onscreen
instructions.
4. Before exiting, select File>Save Changes and Exit.

Cable lock (optional)

To prevent theft, the rear chassis panel of the workstation accommodates a keyed cable lock. This cable
lock attaches to the chassis and secures it to the work area. (See
component locations.)
62 Chapter 4 System management
If you do not press the F10
F10
Enter to bypass the title screen, if necessary.
key at the appropriate time, you must restart the workstation,
key again to access the Computer Setup (F10) Utility.
F10 key until you enter the
Rear panel components on page 6 for
ENWW