Installing The Fan And Speaker Assembly - HP x4000 Technical Reference Manual

Figure 10-29 Removing the Fan and Speaker Assembly
Press these
clips.
10. Unclip the two clips on the front of the chassis.
11. Slide the fan and speaker assembly towards the rear of the
Workstation until it is clear of the chassis, then remove it from the
Workstation.

Installing the Fan and Speaker Assembly

1. Ensure all cables are clear of the assembly, then carefully move the
fan and speaker assembly towards the front of the chassis.
2. Align the clips and guide pins with their appropriate sockets and
slide the assembly forward to secure it into place.
3. Replace the screw on the front of the chassis as shown in Figure 10-29
on page 192.
4. Connect the fan and speaker cables to their connectors located on the
system board. See Figure 10-32 on page 198.
5. Insert any PCI and graphics cards. Install the separate graphics
retainer beam. Insert the MEC..
6. Replace the chassis beam assembly as described in "Installing the
Chassis Beam Assembly" on page 153.
7. Close and secure the hard disk drive cage as described in "Closing
and Securing the Hard Disk Drive Cage" on page 150.
Chapter 10
This manual downloaded from http://www.manualowl.com
Installing or Replacing Parts and Accessories
Fan and Speaker Assembly
Remove this
screw.
193