HP Z800 Maintenance And Service Manual page 50

Table 4-1
Heading
Security
38 Chapter 4 System management
Computer Setup (F10) Utility menu descriptions (continued)
Option Description
Setup Password Enables you to set and enable a setup password for the administrator.
If you create a setup password, you must use it to change workstation setup options, to flash the
ROM, and to make changes to certain Plug and Play settings under Windows.
Power-On Enables you to set and enable the power-on password.
Password
Password This option becomes available when you create a setup and/or power-on password. It provides
Options these options:
●
●
●
●
Smart Cover Enables you to enable and disable the cover removal sensor, or to notify you if the sensor is
activated.
Device Security Makes the following devices available or hidden to the workstation:
●
●
●
●
●
●
●
●
●
●
●
●
For each device, Device Available is the default setting and allows the operating system to access
the device. Device Hidden makes the device unavailable; it is disabled by the BIOS and cannot
be enabled by the operating system.
NOTE:
DriveLock-compatible hard disk drive.
Lock Legacy Resources—Prevents the operating system from changing resources to serial,
parallel, or diskette controller.
Network Server Mode—Enables network server mode.
Password Prompt on Warm Boot—Enables a password prompt on a warm boot.
Setup Browse Mode—Enables read-only functionality for password info.
Serial Port
Front USB Ports
Rear USB Ports
Internal USB Ports
System Audio
IEEE 1394 Controller (Not available on some models.)
Ethernet Controller
Ethernet Controller (ASF) (Not available on some models.)
SAS Controller (Not available on some models)
Legacy Diskette
Embedded Security Device
SATA 0-n
An entry for enabling DriveLock appears in the setup menu if the workstation has a
ENWW