Removing A Dimm - HP Z800 Maintenance And Service Manual

Removing a DIMM

1. Disconnect power from the workstation (see
CAUTION:
the workstation and unplug the power cord from the AC power outlet. If you do not unplug the
power cord before installing memory, the modules might be damaged and the workstation will not
recognize the memory changes.
2. Remove the side access panel (see
3.
Remove the airflow guide
4. Remove the memory fans (see
5.
Carefully push outward on the memory slot socket levers (1). Lift the DIMM straight up and out of
its socket (2), as shown in the following figure.
Store the DIMM in an anti-static bag.
Figure 5-88
160 Chapter 5 Replacing components
To ensure that DIMMs are not damaged during removal or installation, power off
Removing the side access panel on page
(Removing the airflow guide on page
Removing the memory fans on page
Removing a DIMM
Predisassembly procedures on page
80).
155).
77).
79).
ENWW