Installing The Expansion Card Guide/Front Fan Holder - HP Z800 Maintenance And Service Manual

Installing the expansion card guide/front fan holder

1. Ensure that the fan holder includes the desired cooling fans (see
fan on page
2. With power off to the workstation and the chassis open, place the expansion card guide/front fan
holder assembly in the chassis. Place the tabs at the bottom of the assembly into the slots in the
chassis as shown in the following figure (1).
NOTE:
there are no cables between the fans and the chassis mounting wall. All workstation cables should
be located under the card guide.
TIP:
To engage the hooks, you might have to press down firmly on the card guide/fan holder to
overcome cable resistance.
3. Rotate the assembly up until it snaps into place (2).
4.
Connect the cooling fan power cables to the system board (see
on page
5.
Reinstall all removed components and reconnect any cables that have been disconnected.
ENWW
149).
When positioning the expansion card guide/front fan holder into the chassis, make sure
149).
Installing a second front system
Installing a second front system fan
Removing and installing components 145