Cpu; Removing A Cpu - HP Z800 Maintenance And Service Manual

CPU

This section describes how to remove and install a CPU.

Removing a CPU

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3.
Remove the expansion card support (see
4. Remove the airflow guide (see
5. Remove the memory fan assembly (see
6. Remove the CPU heatsink (see
7.
Raise the CPU socket lever (1), and then open the cover (2), as shown in the following figure.
Figure 5-126
CAUTION:
socket contacts or the gold pads underneath the CPU. Use extreme care and handle the CPU only
by the edges.
8. Pull the CPU straight out of the socket (3), and store the CPU in a static free container in a safe
place where it cannot be damaged
ENWW
Removing the side access panel on page
Removing the airflow guide on page
Removing the CPU heatsink on page
Removing a CPU
The CPU socket contacts and pads are extremely fragile. Do not touch the CPU
Predisassembly procedures on page
Removing the expansion card support on page
Removing the memory fans on page
Removing and installing components
77).
79).
82).
80).
155).
199).
203