Installing A Pcie Card - HP Z800 Maintenance And Service Manual

Installing a PCIe card

1. Disconnect power from the workstation (see
2. Remove the side access panel (see
3.
Remove the expansion card support (see
4. Select the desired expansion card slot for the PCIe card. See
on page 168
5. Raise the rear retention clamp by lifting the metal bar or the green lever (1), as shown in the
following figure.
Figure 5-96
TIP:
Grasp the slot cover between two fingers—one from the inside of the chassis, and one from
the outside.
6. Remove the PCI slot cover by pulling it up, out of the chassis (2).
ENWW
Removing the side access panel on page
for help in selecting a slot.
Removing the slot cover
Predisassembly procedures on page
Removing the expansion card support on page
Choosing an expansion card slot
Removing and installing components
77).
79).
82).
171