HP Z800 Maintenance And Service Manual page 267

Table 6-10
Screen message
1802—Processor Not
Supported
1803—Processor feature set is
insufficient for current system
settings
1804—A processor feature
and the memory configuration
are incompatible
ERROR: invalid 1394 GUID
ERROR: Invalid electronic
serial number
ERROR: An unsupported
processor is installed. System
halted
ERROR: A processor requiring
too much power is installed.
System halted
ERROR: Mixing processors
with different power
requirements. This is not
supported. System halted.
Invalid electronic serial
number
Mixing processors with
different power requirements.
This is not supported. System
halted.
Mixing Two Different
Processor Types MP and DP!!!
Network Server Mode Active
and No Keyboard Attached
Processor initialization fails!!!
The installed CPUs have
different voltage requirements.
This is not supported. System
halted.
Two processors do not have
the same frequency operating
ranges!!!
ENWW
POST error messages (continued)
Probable cause
The system board does not support the
processor.
Processor feature set is insufficient for
current system settings. The BIOS
settings do not match the support
provided by the processor
A processor feature is incompatible
with the memory configuration.
BIOS installed incorrect UUID for the
IEEE-1394 interface.
No electronic serial number is stored
with the system
Unsupported processor detected.
Unsupported processor detected.
Mixed type processors detected.
Incorrect serial number registered in
the system.
Mixed type processors detected.
Mixed type processors detected.
Keyboard not detected.
Processor defective.
Mixed type processors detected.
Mixed type processors detected.
Recommended action
Replace the processor with a compatible one.
Change the BIOS settings or upgrade the processors.
Restore the previous memory configuration.
Replace the system board.
To assign a serial number , select Security >System
IDs in the Computer Setup (F10) Utility.
Replace the processor.
Replace the processor.
Replace the processors with matched processors.
Use the Computer Setup (F10) Utility to reset the serial
number.
Replace the processors with matched processors.
Replace the processors with matched processors.
Verify that a functioning keyboard is attached to the
workstation.
Replace the processor.
Replace processors with matched processors.
Replace processors with matched processors.
Diagnostic codes and errors 255