Download  Print this page

Replicating The Setup; Copying A Setup Configuration To A Single Workstation - HP Z800 Maintenance And Service Manual

Hide thumbs

Advertisement

Replicating the setup

This section provides information about replicating the workstation setup.

Copying a setup configuration to a single workstation

CAUTION:
target workstations are not the same model.
To copy a setup configuration:
1.
Select a setup configuration to copy, and then restart the workstation.
2.
Power off the workstation you are configuring and insert the configuration diskette into the diskette
drive or USB media device.
3.
As soon as the workstation powers on, press and hold
(F10) Utility. If necessary, press
NOTE:
then press and hold
If you are using a PS/2 keyboard, you might see a keyboard error message. Disregard it.
4.
Select File>Replicated Setup>Save to Removable Media. Follow the instructions on the
screen to create the configuration diskette or USB media device.
5.
Power on the workstation you are configuring.
6.
Press and hold the
Enter
7.
Select File>Replicated Setup>Restore from Removable Media, and then follow the
instructions on the screen.
8.
Restart the workstation when the configuration is complete.
46
Chapter 4 System management
A setup configuration is model-specific. File system corruption can result if source and
If you do not press
F10
F10
again to access the utility.
F10
key until you enter the Computer Setup (F10) Utility. If necessary, press
to bypass the title screen.
F10
Enter
to bypass the title screen.
at the appropriate time, you must restart the workstation, and
until you enter the Computer Setup
ENWW

Advertisement

Table of Contents

   Related Manuals for HP Z800

Comments to this Manuals

Symbols: 0
Latest comments: