Configuration; Link Configuration; Inspection; Figure 3-1 Link Positions - GE GBX24 Hardware Reference Manual

3 • Configuration

3.1 Link Configuration

The GBX24 has push‐on jumpers included in the standard kit of parts; additional
jumpers may be obtained on request. These are suitable for level 1 to 3 low vibration
applications.

Figure 3-1 Link Positions

Figure 3‐1 shows standard 2.54 mm pitch headers for general use.
This manual refers to jumper settings as In or Out. Meanings are as follows:
In = jumper fitted ‐
Out = jumper not fitted ‐

3.2 Inspection

The GBX24 is shipped from the factory with no configuration jumpers fitted.
Publication No. GBX24-0HH/2
TIP
For Level 4 and 5 products, make links by wire-wrapping between the pin posts and then cover these
wire wrapped links with the same conformal coating as that used on the board. This will provide a
reliable connection under heavy shock and vibration conditions and further prevent oxidation of the
connection due to moisture ingress.

Configuration 17