Set The Lsp Transition Points; Configure An X330 Expansion Module (If Necessary); Issue 3 — May - Avaya G700 Installation And Upgrades

4 Installing a New G700 without an S8300: Configure the G700
Link Status says
H248 Link Status says

Set the LSP Transition Points

You must set the time that the G700 searches, in the event of a network problem, for primary controllers (for
example, additional CLAN connections) with which to register. After this search time has elapsed, the G700
will search for an LSP with which to register. You must also set the total time the G700 searches for either a
primary controller and an LSP, after which the G700 resets. And finally, you must define how many primary
controllers, from 1 to 4, are in the controller list you just defined.
1. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-
search <search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is from
2. At the MG-001-1(configure)# prompt, type set mgp reset-times total-
search <search-time>
where <search-time> is the time in minutes that the G700 searches for both primary
controllers or LSPs. The range is from
At the MG-001-1(configure)# prompt, type set mgp reset-times transition-
3.
point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the
primary controller is an S8700, the range is from
<#_of_primary> must be
Configure an X330 Expansion Module (If
Necessary)
Note: You cannot use the AIW to perform this task.
See the Avaya X330W-2DS1 Access Router Module Quick Start Guide. This document is
4.
available at http://avayanetwork.com. Once there, select:
> Software Download
> Avaya P330
> Technical Documentation
5. Select the Quick Start Guide for X330WAN 2DS1.
180
UP . If the controller is not running, the Registered field says
.
DOWN
1 .
> Avaya X330 WAN
Installation and Upgrades for G700 with S8300 or S8700
to .
1 60
1 to 60 .
to If the primary controller is an S8300,
1 4.
555-234-100 — Issue 3 — May 2003
NO and the