Avaya G700 Installation And Upgrades page 158

3 Installing a New G700 with an S8300: Set Up SNMP Alarming on the G700
Note: Do these steps only if the S8300 is the primary controller and the customer has a
maintenance contract with Avaya. Use the information you acquired from the
ART tool (see
USB modem must have already been installed.
With a direct connection to the S8300 Services port, start a Telnet session and log in as
1.
1 . At the prompt, type almcall -f INADS phone number -s <second-number>
and press
2 . At the prompt, type almenable -d b -s y and press
3 . Type almenable and press
4 . Log off.
Configure an SNMP Community String for Traps
Configuring the G700 Media Gateway to send SNMP traps to the primary server can be
accomplished by two commands:
• P330 stack processor CLI command set snmp community trap [community string]
• Media Gateway Processor (MGP) CLI command set snmp trap <IP address> enable
SNMP requires community strings to be used for each SNMP 'request'. You can set only three
community strings on the G700 — one each for read requests, write requests, and traps. The
command for traps is set snmp community trap [community string].
1. Telnet to the P330 stack processor.
Log in as root.
2.
3. At the P330-1(super)# prompt, type set snmp community trap [community
string] and press
4. Type exit
Configure the Destination for G700 SNMP Traps
Events occurring on the G700 cause SNMP traps to be generated. The G700 MGP can be configured
to send SNMP traps to any network management system (NMS) in the network, including the
primary server (S8300/S8700). The MGP CLI set snmp trap command is the way to configure
the NMS network element that will receive those traps.
The command syntax is:
set SNMP trap <IP address> {enable|disable}
[{all|power|temp|app|module|config|voice|operations}]
where <IP address> is the IP address of the NMS trap receiver that will be receiving the
traps from the G700, and
[{all|power|temp|app|module|config|voice|operations}] indicates the
groups whose traps will be sent to the specified receiver. If no keywords follow the IP address
entry, then 'all' traps will be enabled for the specified receiver.
If 'enable' or 'disable' is used without a trap designation keyword, then 'all' traps is assumed. Up
to ten trap receivers can be configured.
158
Run the ART Tool for the INADS IP Address, if Necessary
.
Enter
Enter
.
Enter
Installation and Upgrades for G700 with S8300 or S8700
Enter
to verify that the alarms are enabled.
555-234-100 — Issue 3 — May 2003
). Also, a
craft
.
.