Configure the Server
After the S8300 software upgrade is complete, you must run the complete Configure Server wizard from the
S8300 web page. Because this is part of an upgrade procedure rather than an initial installation, you should
not need to enter any information for this configuration procedure. However, you do need to do the
complete configuration procedure by clicking the Continue button on each of the configuration screens.
On the S8300 Web page main menu, click on
1.
Upgrade. The system displays the Configure Server screen.
Click
2.
Continue
The system displays the Back Up Data notice.
Ignore the backup instruction. Click
3.
The system displays the Select method for configuring the server screen.
Select "Configure all services using the wizard," and click
4.
5.
On each remaining configuration screen, click
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
5 Upgrading an Existing G700 with an S8300: Configure the Server
.
Continue
under Server Configuration and
Configure Server
.
.
Continue
Continue
until the configuration is complete.
229