Complete The Installation Of S8300; (If The Primary Controller) - Avaya G700 Installation And Upgrades

3 Installing a New G700 with an S8300: Complete the Installation of S8300 (if the Primary Controller)
1. At the P330-1(super)# prompt, type session mgp
At the mg-xxx-n(super-user)# prompt, type configure and press
2.
3. At the mg-xxx-n(configure)# prompt,
type set snmp trap <IP address> enable and press
4. Type exit

Complete the Installation of S8300

(if the Primary Controller)

Consult the planning documentation to obtain the necessary information to complete the installation. Part of
the final process will be to:
• Connect and administer test endpoints
• Test the endpoints
• Administer Communication Manager for trunks, features, networking, or other items required by
the customer.
• Complete the electrical installation
• Enable adjunct systems
Register the system
Follow the existing process and procedures to register the S8300.
Back up the System
Make sure you have the IP address of the customer's FTP backup server.
1.
2. On the S8300 main menu, select
The system displays the Backup Now screen.
3. Select the type of data you want to back up by selecting the appropriate data set.
Select a backup method, normally
4.
backup data.
Complete the following fields:
5.
User name
server. If you want to use the anonymous account, type "anonymous" in this field. If you do not
want to use the anonymous account, type the actual user name in this field.
Password
anonymous as the user name, you must use your email address as the password. However, the FTP
site may have a different convention.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
Backup Now
FTP
. You must enter a valid user name to enable the media server to log in to the FTP
. You must enter a password that is valid for the user name you entered. If you are using
.
, to indicate the destination to which the system sends the
.
Enter
.
Enter
159