Install New Firmware On Other G700 Media Gateways; Configuration) - Avaya G700 Installation And Upgrades

3 Installing a New G700 with an S8300: Install New Firmware on the G700
The G700 and P330 at the bottom of the stack is module number 1, the next module up is number 2,. and so
on. However, the stack master can be any module in the stack, depending on the actual model, the vintage
firmware it runs, and whether the S8300 is inserted into it.
Note: You do not need to configure the other P330 stack processors in the stack. These
will use the IP address and IP route of the master stack processor. However, you
will need to check firmware on all devices of the other G700s in the stack,
including the media gateways themselves, and update the firmware as required.
You may also use the "session stack" command to access other standalone P330
processors in the stack (those that are not part of a G700 unit).
At the MG-001-1(configure)# prompt, type session stack
1.
The P330-1(configure)# prompt appears.
At the P330-1(configure)# prompt, type session <mod_num> mgp
2.
<mod_num> is the next P330 processor in the stack. If you are currently logged in to the master
stack processor, <mod_num> would be 2, for the second G700/P330 processor in the stack.
3. For other G700s in the stack, repeat the steps described previously to install firmware for the stack
processor, MGP, and media modules.
Install New Firmware on Other G700 Media Gateways (Remote, No Stack Configuration)
If additional G700 media gateways are supported in the configuration, but they are not attached as a stack,
then you must configure each G700, with all of its devices, including the P330 processors. Additionally, you
must check firmware and update the firmware as required.
138
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003