Administer Ip Interfaces - Avaya G700 Installation And Upgrades

3 Installing a New G700 with an S8300: Administer Communication Manager

Administer IP Interfaces

Define the IP interfaces of the S8700 port network CLAN boards
Note: This should have already been established as a part of normal S8700 installation.
Type change ip-interfaces to open the IP Interfaces screen.
1.
IP Interfaces Screen
change ip-interfaces
Enable
Eth Pt Type Slot
y C-LAN 02C18 TN799
n MEDPRO 02C08 TN802
y MEDPRO 02C11 TN2302
y C-LAN 02B17 TN799
y C-LAN 01A06 TN799
y MEDPRO 02C13 TN2302
y MEDPRO 02C15 TN2302
n MEDPRO 02C16 TN2302
2. Complete the fields as described the in the following table.
Field
Enable Eth Pt The Ethernet port must be enabled (y) before it can be used.
The port must be disabled (n) before changes can be made to
its attributes on this screen.
Type Either C-LAN.
Slot The slot location for the circuit pack.
Code Display only. This field is automatically populated with TN799
for C-LAN.
Sfx Display only. This field is automatically populated.
Node name The unique node name for the IP interface. The node name
here must already be administered on the Node Names
screen.
150
IP INTERFACES
Code Sfx Node Name
C st7clan
B st7_mp1
st7_prowler1
C st7clan3
C st7clan4
st7_prowler6
st7_prowler7
st7_prowler8
Conditions/Comments
Installation and Upgrades for G700 with S8300 or S8700
Page 1 of
Subnet Mask Gateway Address Rgn
255.255.0 .0 172.23 .23 .254 80
255.255.255.0 192.168.22 .254 6
255.255.0 .0 172.23 .23 .254 7
255.255.0 .0 172.23 .23 .254 6
255.255.0 .0 172.23 .23 .254 80
255.255.0 .0 172.23 .23 .254 1
255.255.0 .0 172.23 .23 .254 80
255.255.0 .0 172.23 .23 .254 80
1 of 2
555-234-100 — Issue 3 — May 2003
6 SPE B
Net