Avaya G700 Installation And Upgrades page 127

6. Type set interface mgp <vlan> <ip_address> <netmask> to assign an IP
address to the G700 Media Gateway. <vlan> is the vlan to be established on the customer's
local network. This is usually
for the G700 Media Gateway.
!
CAUTION:
If this G700 contains an S8300 configured as an LSP, use the VLAN administered on the
primary controller.
At the MG-???-n(configure)# prompt, type reset mgp.
7.
A system prompt asks to confirm the reset.
Select
8. Yes
The G700 Media Gateway processor will reset. The LEDs on the G700 Media Gateway and the
Media Modules will flash. These elements will each conduct a series of self-tests. When the LEDs
on the Media Modules are extinguished and the active status LEDs on the G700 Media Gateway
are on, the reset is complete.
Log in again at the
9.
10. At the P330-1(configure)# prompt, type session mgp.
At the MG-???-1(super)# prompt, type configure to reach the configuration level of the
11.
command line interface.
Type show interface mgp to verify that the G700 Media Gateway has the correct IP
12.
address.
Assign the Default IP Route to the G700 Media Gateway
1. At the MG-???-n(configure)# prompt, type set ip route <destination>
<netmask> <gateway_ip_address>. Both <destination> and <netmask> are
0.0.0.0 for the default gateway. <gateway_ip_address> is the IP address of the local
network segment.
Type show ip route mgp to view the results.
2.
Repeat step 1
3.
your planning document.
Assign IP Addresses to the VoIP Resources
From the G700 Media Gateway Processor command line interface, you will assign IP addresses to
the VoIP resource resident on the G700 Media Gateway and to any installed MM760 VoIP Media
Modules.
At the MG-???-n(configure)# prompt, type set interface voip <number> <ip
1.
address>
<number> is the slot number of the VoIP media module.
resident on the G700 Media Gateway motherboard. The MM760 VoIP Media Modules are
designated according the slot (for example,
installed. <ip address> is the IP address of the VoIP resource.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
3 Installing a New G700 with an S8300: Configure the G700 Media Gateway
. The <ip_address> <netmask> is the assigned addresses
1
at the dialog box that asks if you want to continue.
Welcome to P330
for additional ip routes, if needed. Usually, only a default route is needed. Refer to
menu.
v0 designates the VoIP resource
, , , ) in which the Media Module has been
v1 v2 v3 v4
127