Configure An X330 Expansion Module (If Necessary) - Avaya G700 Installation And Upgrades

primary controller and an LSP, after which the G700 resets. And finally, you must define how many primary
controllers, from 1 to 4, are in the controller list you just defined.
1. At the MG-001-1(configure)# prompt, type set mgp reset-times primary-
search <search-time>
where <search-time> is the time in minutes that the G700 searches for a primary controller
before looking for an LSP. The range is from
At the MG-001-1(configure)# prompt, type set mgp reset-times total-
2.
search <search-time>
where <search-time> is the time in minutes that the G700 searches for both primary
controllers or LSPs. The range is from
At the MG-001-1(configure)# prompt, type set mgp reset-times transition-
3.
point <#_of_primary>
where <#_of_primary> is the number of primary controllers in the controller list. If the
primary controller is an S8700, the range is from
<#_of_primary> must be
Configure an X330 Expansion Module (If
Necessary)
Note: You cannot use the AIW to perform this task.
See the Avaya X330W-2DS1 Access Router Module Quick Start Guide. This document is
4.
available at http://avayanetwork.com. Once there, select:
> Software Download
> Avaya P330
> Technical Documentation
Select the Quick Start Guide for X330WAN 2DS1.
5.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
3 Installing a New G700 with an S8300: Configure the G700 Media Gateway
1 .
> Avaya X330 WAN
1 to 60 .
1 to 60 .
to If the primary controller is an S8300,
1 4.
131