The Primary Controller Is An S8700; (The S8300 Is An Lsp); Assign Node Names And Ip Addresses For The C-Lans And Lsps - Avaya G700 Installation And Upgrades

The Primary Controller is an S8700

(the S8300 Is an LSP)

!
CAUTION:
This administration applies only to an S8700 that serves as the primary controller for the
target G700. Do not administer Communication Manager on the S8300 (LSP). Translations
are automatically copied to the LSP from the S8700 primary controller after a save
translations command or a data backup.
If the primary controller is an S8300, skip this section and go to
page 139.
Note: Some of the procedures in this section should have been completed previously as
part of a normal S8700 installation.
This document covers only the administration of Communication Manager required for the G700 Media
Gateway to communicate with the primary controller over a customer's network. For the majority of
required administration, see ''Administrator's Guide to Avaya™ Communication Manager, 555-233-506,''
or ''Administration for Network Connectivity for Avaya™ Communication Manager, 555-233-504.''
In this section, you will use the SAT interface to:
• Assign Node Names
• Define the IP Network Region
• Add a Media Gateway
Note: For information on installing the CLAN boards on the S8700 port networks and
complete information on installing an S8700 Media Server, see the Installation
documentation on the ''Avaya S8300 and S8700 Media Server Library CD, 555-
233-825.''

Assign Node Names and IP Addresses for the C-LANs and LSPs

Note: The CLAN boards must be TN799DP running version 5 or greater firmware. Be
sure to check the firmware version for these boards on the S8700. For
information on how to upgrade the firmware on the S8700, please see the section
"Upgrade Firmware in Selected Port Cabinet Packs" in Upgrading the Avaya
Media Server Configuration in the S8700 documentation portion of this
documentation CD, ''Avaya S8300 and S8700 Media Server Library CD, 555-
233-325.''
Assign node names and IP addresses
At the S8700 SAT prompt, type change node-names ip to open the Node Names screen.
1.
2. Go to page 2
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
3 Installing a New G700 with an S8300: Administer Communication Manager
"The Primary Controller is an S8300" on
145