Insert The Avaya S8300 Media Server (If Necessary For Standalone Service Or Lsp) - Avaya G700 Installation And Upgrades

2 Installing Hardware for the G700 Media Gateway and S8300 Media Server: Installation and Cabling
4. Tighten the mounting screws. Avoid overtightening.
Verify that ventilation vents are not obstructed.
5.
6. Repeat to add other G700 Media Gateways to the rack as described in the planning documents.
If you are installing multiple G700s, continue building the stack. Up to 10 units can be linked together
(Figure 13); these may be G700s or Avaya P330 family switches.
At this point, you have mounted the G700 chassis in the rack and are ready to insert S8300 Media Servers
and media modules as required in the planning documentation.
Insert the Avaya S8300 Media Server
(If Necessary for Standalone Service or LSP)
The S8300 Media Server is inserted into the G700 Media Gateway slot #1 (v1), whether it is the primary
server or configured as a Local Survivable Processor (LSP). The S8300 can only be inserted in the slot (v1)
on the left side of the G700 Media Gateway. The LED module must be pulled from the G700 chassis to
provide clearance for the S8300 Media Server.
Note: If you need to install the CWY1 card (for embedded messaging) on the S8300, do
so now.
!
CAUTION:
If you are removing an S8300, use the shutdown button to stop the operating system (press
and hold for 2-3 seconds). The OK to Remove LED will flash while the shutdown is in
progress and will turn steady green when it is safe to remove the S8300.
Insert the S8300 into Slot #1 of the G700 Media Gateway
Clear the left side of the G700 Media Gateway.
1.
a . Remove the blank plate from slot #1.
b . Then, disengage the LED module and remove it from the G700 Media Gateway.
Line up the Avaya S8300 Media Server module squarely with its bay opening.
2.
Figure 7. Clear the left side of the G700 Media Gateway
3. Engage both sides of the S8300 Media Server module in the interior guides and guide the module
halfway into the chassis.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
73