D Replacing The G700 Media Gateway - Avaya G700 Installation And Upgrades

Media gateway controlled by media server
Hide thumbs Also See for G700:
Table of Contents

Advertisement

D
Replacing the G700 Media Gateway
Circumstances may require that the G700 Media Gateway be replaced, either because of hardware/firmware
failure, or because of newer technology. Depending upon these circumstances, some or all of the
components inserted into the G700 (S8300 Media Server, LED Panel, Avaya Expansion Module, Avaya
Octaplane Module, or various Media Modules) may be reused in the replacement G700.
To replace the G700, follow these steps:
1 . If the original G700 is still in operation, power down the system. This should be done at a time
when there will be the minimum interruption in service.
a . Perform a shutdown of the S8300 Media Server, if present, using either the Web interface or
manually, using the shutdown button on the S8300 faceplate.
b . Power down the G700 by removing the power cord from the wall power source.
2 . Remove all media modules from the G700, and carefully set aside (assuming they will be
reused).
3 . Reversing the procedures documented in Chapter 2, Installation and Upgrades for an Avaya™
G700 Media Gateway controlled by an Avaya™ S8300 Media Server or an Avaya™ S8700 Media
Server, 555-234-100, remove the G700 from its rack mount.
4 . Then, following these same procedures, install the replacement G700 hardware into the rack
mount.
5 . Proceed as you would for the installation of a new G700. Follow the procedures documented in
Installation and Upgrades for an Avaya™ G700 Media Gateway controlled by an Avaya™ S8300
Media Server or an Avaya™ S8700 Media Server, 555-234-100.
6 . Install the S8300 Media Server, LED Panel, and media modules.
7 . Contact RFA, if you have not already done so, and download new license and authentication files
to match the serial number of the replacement G700.
8 . Power up the system, and install the new license and authentication files.
9 . In Communication Manager, running on the primary server, use the
SAT command to enter the new G700 serial numbers and other data.
Installation and Upgrades for G700 with S8300 or S8700
555-234-100 — Issue 3 — May 2003
change media-gateway
305

Advertisement

Table of Contents
loading

This manual is also suitable for:

S8300S8700

Table of Contents