Adding Media Gateways - Avaya IG550 Installing And Configuring

Administering Communication Manager on the media server to support the IG550 Integrated Gateway

Adding Media Gateways

1. At the SAT prompt, type add media-gateway <number>
where <number> is the gateway number from 1 to n. (n is 50 for an S8300, 5 for an S8400,
and 250 for an S8500 or S8700-series Media Server).
The Media Gateway screen appears.
change media-gateway 1
Number: 1
Serial No: 012X06230551
Encrypt Link? y
Network Region: 1
Location: 1
Recovery Rule: 1
Slot
V1:
V2:
V3:
V4:
V5:
V6:
V9:
2. Complete the Name field with the hostname assigned to the router.
3. Complete the Identifier field with the serial number of the TGM550.
!
CAUTION:
Be sure the serial number for the TGM550 you enter is correct. The serial
CAUTION:
number is case-sensitive, and if entered incorrectly, will prevent the media server
from communicating with the TGM550. This number is available from a sticker
attached to the TGM550 or can be identified with the show system command
on the TGM550.
4. Enter y or n in the Encrypt Link field.
5. Complete the Network Region field with the value supplied in the planning documentation.
6. Enter the location number in the Location field. Since the location sets the timezone and
daylight savings rules, you normally assign the same location as that of the media server.
128 Installing and Configuring the IG550 Integrated Gateway
MEDIA GATEWAY
Type: j4350
Name: Swainsons
Module Type
TGM550
TIM514
TIM510
TIM521
Registered: y
FW Version/HW Vintage: 21.13.0 /0
IP Address: 135.9.41.150
Controller IP Address: 135.9.41.146
MAC Address:
Site Data:
DSP Type FW/HW Version
Name DAR1
ANA MM
ANA MM
DS1 MM
BRI MM
Max Survivable IP Ext: 8
Page 1 of 1
1 0