Table of Contents
Advertisement
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
STPD Status for
If a port is added to a VLAN by GVRP, the newly added port reflects
GVRP-Added
the SPTD membership and status of the VLAN to which it is added.
For example, if VLAN Red is a member of STPD s0, and s0 is enabled,
Ports
then all ports added to VLAN Red by GVRP have s0 enabled on those
ports, as well. The command for disabling STP on a port basis has no
permanent affect on ports controlled by GVRP.
Note
For more information on GVRP, refer to
Chapter
4.
Defaults
The default device configuration contains a single STPD called s0.
The default VLAN is a member of STPD s0.
All STP parameters default to the IEEE 802.1D values, as appropriate.
6-3
Advertisement
Table of Contents
