Ipx/Rip Routing - Allied Telesis AT-9108 User Manual

IPX/RIP Routing

IPX/RIP Routing
11-4
The switch supports the use of IPX/RIP for unicast routing. IPX/RIP is
different from IP/RIP. However, many of the concepts are the same.
ExtremeWare supports the following IPX/RIP features:
Split horizon
Poison reverse
Triggered Updates
For more information on RIP concepts, refer to
Route information is entered into the IPX route table in one of the
following two ways:
Dynamically, by way of RIP
Statically, using the command:
config ipxroute add [<dest_netid> |
default] next_hop_netid next_hope_node_addr
<hops> <ticks>
IPX/RIP is automatically enabled when a NetID is assigned to the
VLAN. To remove the advertisement of an IPX VLAN, use the
command:
config ipxrip delete {vlan <name> | all}
GNS Support. ExtremeWare support the Get Nearest Server (GNS)
reply function. When a NetID is assigned to the switch, the GNS reply
service is automatically enabled. When a station requests a particular
service on the network (for example, locating a print server), the
station sends a GNS request and the switch responds to the request.
If GNS-reply is disabled, the switch drops the request.
To disable GNS-reply, use the following command:
disable ipxsap gns-reply {vlan <name>}
Note
Chapter 9.