Ip Host Configuration Commands - Allied Telesis AT-9108 User Manual

IP Host Configuration Commands

Command
config iparp add <ipaddress>
<mac_address>
config iparp delete <ipaddress>
clear iparp {<ipaddress> | vlan <name>}
config iproute add <ipaddress> <mask>
<gateway> {<metric>}
config iproute delete <ipaddress>
<mask> <gateway>
config iproute add default <gateway>
{<metric>}
config iproute delete default <gateway>
show ipconfig {vlan <name>}
show ipstats {vlan <name>}
show iproute {priority | vlan <name> |
permanent | <ipaddress> <mask>}
show iparp {<ipaddress | vlan <name> |
permanent}
Table 2-5 describes the commands that are used to configure IP
settings on the switch.
Table 2-5 IP Host Configuration Commands
Description
Adds a permanent entry to the Address Resolution
Protocol (ARP) table. Specify the IP address and
MAC address of the entry.
Deletes an entry from the ARP table. Specify the IP
address of the entry.
Removes dynamic entries in the IP ARP table.
Permanent IP ARP entries are not affected.
Adds a static address to the routing table. Use a
value of 255.255.255.255 for mask to indicate a host
entry.
Deletes a static address from the routing table.
Adds a default gateway to the routing table. A
default gateway must be located on a configured IP
interface. If no metric is specified, the default metric
of 1 is used.
Deletes a default gateway from the routing table.
Displays configuration information for one or all
VLANs.
Displays IP statistics for the CPU of the switch or for
a particular VLAN.
Displays the contents of the IP routing table.
Displays the IP ARP table. You can filter the display
by IP address, VLAN, or permanent entries.
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
2-19