Sntp Configuration Commands; Sntp Example - Allied Telesis AT-9108 User Manual

SNTP
Configuration
Commands
Command
enable sntp-client
disable sntp-client
config sntp-client [primary | secondary]
server [<ipaddress> | <host_name>]
config sntp-client update-interval
<seconds>
show sntp-client

SNTP Example

Table 2-8 describes SNTP configuration commands.
Table 2-8 SNTP Configuration Commands
Description
Enables Simple Network Time Protocol (SNTP) client
functions.
Disables SNTP client functions.
Configures an NTP server for the switch to obtain
time information. Queries are first sent to the
primary server. If the primary server does not
respond within 1 second, or if it is not synchronized,
the switch queries the second server.
Configures the interval between polling for time
information from SNTP servers. The default setting
is 64 seconds.
Displays configuration and statistics for the SNTP
client.
In this example, the switch queries a specific NTP server and a
backup NTP server. The switch is located in Cupertino, CA, and an
update occurs every 20 minutes. The commands to configure the
switch are as follows:
config timezone -240 autodst
enable sntp-client
config sntp-client primary server 10.0.1.1
config sntp-client secondary server 10.0.1.2
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
2-25