Ipx Commands - Allied Telesis AT-9108 User Manual

IPX Commands

IPX Commands
Command
enable type20 forwarding {vlan <name>}
config ipxmaxhops <number>
config vlan <name> xnetid <netid>
[enet_ii | enet_8023 | enet_8022 |
enet_snap]
config ipxroute add [<dest_netid> |
default] <next_hop_id>
<next_hop_node_addr> <hops> <tics>
config ipxroute delete [<dest_netid> |
default] <next_hope_netid>
<next_hope_node_addr>
11-8
Table 11-3 describes the commands used to configure basic IPX
settings.
Table 11-3 Basic IPX Commands
Description
Enables the forwarding of IPX type 20 (NetBIOS
inside IPX) packets from one or more ingress
VLANs. The default setting is disabled.
Configures the IPX maximum hop count when
forwarding IPX packets. The default setting is 16.
Change this only if NetWare Link Services Protocol
(NLSP) is running in the IPX network.
Configures a VLAN to run IPX routing. Specify:
Adds a static IPX route entry in the IPX route table.
Specify:
Up to 64 static routes can be entered.
Removes a static IPX route entry from the route
table.
enet_ii — Uses standard Ethernet 2 header.
enet_8023 — Uses IEEE 802.3 length field,
but does not include the IEEE 802.2 LLC header.
enet_8022 — Uses standard IEEE format and
uses IEEE 802.2 LLC header.
enet_snap — Adds Subnetwork Access
Protocol (SNAP) header to IEEE 802.2 LLC
header.
next_hop_id — The NetID of the neighbor
IPX network.
next_hop_node_addr — The node address
of the next IPX router.
hops — The maximum hop count.
tics — The timer delay value.