Table of Contents
Advertisement
Modifying a QoS
Profile
Creating and
Deleting a QoS
Profile
You can modify the default profiles as desired. To modify the
parameters of an existing QoS profile, use the following command:
config qosprofile <qosname> {minbw <percent>}
{maxbw <percent>} {priority <level>}
In egress mode, up to 28 additional custom QoS profiles can be
created on the switch. Because ingress mode (the default) uses the
four pre-defined QoS profiles, you cannot create custom QoS profiles
when using ingress mode.
To create a QoS profile in egress mode, use the following command:
create qosprofile <qosname>
A new QoS profile is created with the following default values:
Minimum bandwidth — 0%
Maximum bandwidth — 100%
Priority — low
These parameters can then be modified, as described previously.
To delete a QoS profile created in egress mode, use the following
command:
delete qosprofile <qosname>
When a QoS profile is removed, all entries previously associated with
the QoS profile are changed to use the settings of the default QoS
profile named qp1.
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
7-5
Advertisement
Table of Contents
