Table of Contents
Advertisement
Understanding the Command Syntax
Syntax Helper
Command
Completion with
Syntax Helper
This section describes the steps to take when entering a command.
Refer to the sections that follow for detailed information on using
the command-line interface.
To use the command-line interface (CLI), follow these steps:
1. When entering a command at the prompt, ensure that you have
the appropriate privilege level.
Most configuration commands require you to have the
administrator privilege level.
2. Enter the command name.
If the command does not include a parameter or values, skip
to Step 3. If the command requires more information,
continue to Step 2a.
a. If the command includes a parameter, enter the parameter
name and values.
b. The value part of the command specifies how you want the
parameter to be set. Values include numerics, strings, or
addresses, depending on the parameter.
3. After entering the complete command, press [Return].
If an asterisk (*) appears in front of the command-line prompt, it
indicates that you have outstanding configuration changes that have
not been saved. For more information on saving configuration
changes, refer to
Chapter
The CLI has a built-in syntax helper. If you are unsure of the complete
syntax for a particular command, enter as much of the command as
possible and press [Return]. The syntax helper provides a list of
options for the remainder of the command.
The syntax helper also provides assistance if you have entered an
incorrect command.
The switch software provides command completion if you press the
[Tab] key. If you enter a partial command, pressing the [Tab] key
posts a list of available options, and places the cursor at the end of
the command.
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
Note
14.
2-2
Advertisement
Table of Contents
