Physical And Logical Groupings - Allied Telesis AT-9108 User Manual

Traffic Groupings and Creating a QoS Policy
Physical and
Logical
Groupings
7-18
Two traffic groupings exist in this category:
Source port
VLAN
Source Port. A source port traffic grouping implies that any traffic
sourced from this physical port uses the indicated QoS profile when
the traffic is transmitted out any other port. To configure a source
port traffic grouping, use the following command:
config ports <portlist> qosprofile <qosname>
VLAN. A VLAN traffic grouping indicates that all intra-VLAN
switched traffic and all routed traffic sourced from the named VLAN
uses the indicated QoS profile. To configure a VLAN traffic grouping,
use the following command:
config vlan <name> qosprofile <qosname>
For example, all devices on VLAN servnet require use of QoS profile
qp4 for both traffic between devices on follows, as well as traffic
sourced on servnet that is routed to other VLANs within the switch.
The command to configure this example is as follows:
config vlan servnet qosprofile qp4
Verifying Physical and Logical Groupings. To verify settings on
port or VLANs, use the command
show qosprofile <qosname>
The same information is also available using the command
show ports info
for ports and
show vlan
for VLANs