Table of Contents
Advertisement
Configuring STP on the Switch
STP configuration involves the following actions:
Create one or more STP domains using the following
command:
create stpd <stpd_name>
STPD, VLAN, and QoS profile names must all be unique. For example,
a name used to identify a VLAN cannot be used when you create an
STPD or a QoS profile.
Add one or more VLANs to the STPD using the following
command:
config stpd <stpd_name> add vlan <name>
Enable STP for one or more STP domains using the following
command:
enable stpd {<stpd_name>}
All VLANs belong to a STPD. If you do not want to run STP on a VLAN,
you must add the VLAN to a STPD that is disabled.
Once you have created the STPD, you can optionally configure STP
parameters for the STPD.
You should not configure any STP parameters unless you have
considerable knowledge and experience with STP. The default STP
parameters are adequate for most networks.
The following parameters can be configured on each STPD:
Hello time
Forward delay
Max age
Bridge priority
AT-9108, AT-8518, AT-8525, and AT-8550 User's Guide
Note
Note
Caution
6-7
Advertisement
Table of Contents
